Sticky-back lamination film is a common protective material used in offices and homes, but many people encounter the problem of bubbles when using it. Today we will share a few simple and practical tips to help you easily apply a smooth lamination film.
Preparation is the key
Clean the surface: Wipe the surface of the object to be applied with a clean, slightly damp cloth before use to ensure that there is no dust, fingerprints and oil stains.
Environment selection: Operate in a clean and dry environment, and avoid pasting in humid or dusty places.
Correct pasting steps
Start from one side: Tear off a small section of the backing paper (about 5 cm) first, and do not tear it all at once.
Position well: Stick the torn part on the edge of the object first to ensure the correct position.
Push slowly: While continuing to tear off the backing paper, push it forward with a credit card or a special scraper.
Keep the angle: Keep a 30-45 degree angle when pasting, so that it is easier to control.
Tips for dealing with bubbles
Small bubbles: Use a needle to poke a small hole, then use a scraper to flatten it around.
Large bubbles: Carefully lift the problematic part and slowly re-apply it.
Stubborn bubbles: Use a hair dryer to heat it at low temperature and then flatten it again.
Purchase and use suggestions
Choose high-quality brand products
Pay attention to the storage environment, avoid high temperature and humidity
Be patient when using, don't rush
Remember these tips, practice more, and you will soon be able to achieve professional-level flatness.